Wednesday, February 27, 2013

Fuel Cell

For this six weeks I chose to build a scale beat fuel booth automobile. This is a part of my graduation proletariat for senior year. I chose this because my faculty advisor teaches the class I worked on it in. I went by a process to have sex this car but it was very interesting, and I learned a lot from it.
I had to browse the web in chase of a way to make a scale mannikin fuel cell car. After many days of seek I stumbled across a process of constructing one through the use of an RC car and a small fuel cell. I read over the details and ordered the parts I needed to build the car. The parts came in after a few days and I began to build the car.
First, I had to tack to stand byher the fuel cell. I followed the steps from the instruction Manuel but changed a few things. Instead of connecting it all to the fuel cell car base I stationed it all on top of the RC car. I could not glue it so I apply some double sided tape to make sure nothing ferocious off when the car became operational. Next after everything was attached I had to find a way to connect the fuel cell to the battery pack. I ordered a chip for the car to help do this, but I could not take care out how to connect it so I came up with an alternating(a) way. I sautered a piece of copper wire to the autocratic and negative terminals of the RC cars battery pack.

Order your essay at Orderessay and get a 100% original and high-quality custom paper within the required time frame.

Then I lodge the wires that were connected from the fuel cell into the battery pack so I could keep a constant current of energy rate of flow from the fuel cell to the car so it would be adapted to move. Next I had to buy the fuel for the cell. For this I used distilled war because regular fountain water cannot pass through the cell due to chemicals in it. I filled the gaseous state storage cylinders with the distilled water. I then attached two six-inch lengths of silicon tubing to the cylinders. I plugged one end of the heat content cylinder tubing into one of the tube stubs on the pitch-dark terminal side of the fuel cell. I plugged different end of the oxygen cylinder tubing into one...If you want to get a full essay, order it on our website: Orderessay



If you want to get a full essay, wisit our page: write my essay .

No comments:

Post a Comment